Pass Labs Launches New, More Affordable XA25 Class A Power Amplifier

“The XA25 is an affordable transition amplifier enabling the discriminating Music Lover to move to Class A Technology.” – Nelson Pass
Auburn, CA, April 21, 2017 – Pass Labs has started shipping their new XA25 Class A Power Amplifier, the most affordable power amplifier in their current line. With 2 x 25W @ 8 ohms, 2 x 50/W at 4 ohms and 2 x 100WClass A/AB at 2 ohms, and priced at $4,900, the XA25 is not meant as merely an “Entry-Level” model, but rather, a more affordable way for consumers to experience the Pass Labs line and all its renowned traditions of founder Nelson Pass’ comprehensive design, construction and performance.
In other words: A smaller, lighter and less expensive Pass Labs Class A power amplifier.
To paraphrase the words of Nelson Pass when describing the new XA25 Power Amplifier: At Pass Labs, we build FET amplifiers with excessive output stages, huge heat sinks and massive power supplies. We use the highest quality components in simple linear topologies, assembled and tested with care and subtlety. They measure well, sound great, and are reliable. Twenty+ years of ongoing innovation have kept the X and XA amplifiers at the forefront of high-end audio.
“The new XA25 is intended to appeal to those wanting the performance without the frills in a
chassis that will fit on a shelf and can be lifted without the assistance of ruffians.” – Nelson Pass
The XA25 embodies all this and less. A smaller Class A stereo amplifier at a lower price, it takes advantage of the lower power requirements to have simpler single-ended circuitry and fewer parts in the signal path. This also allows elimination of degeneration, “that other negative feedback,” in all stages.
Simpler and fewer gain stages improves speed and stability. Lower voltages mean the ability to run gain devices at higher bias currents, more deeply into Class A.
Newer power FET technology replaces banks of parallel small transistors with a single pair of industrial devices, each having a 700 watt / 40 amp rating. With no current-hogging issues and a new constant-current bias circuit to compensate for temperature drift, they connect directly to the loudspeaker without ballast resistors for lowest possible distortion and highest damping factor. No degeneration also increases the efficiency and Class A operating current, allowing greater Class A operation into low impedance and reactive loads.
The simple front end circuit uses two pairs of NOS complementary FETs in common-source mode in a current feedback (CFA) configuration. The amplifier is direct coupled and has no DC servos or frequency compensation. Inputs from the preamplifier or DAC are RCA.
According to Nelson Pass: “As with all Pass amplifiers, the technology and construction are strictly in the service of the listening experience. The XA25 measures superbly, but its subjective qualities are most special. In an industry where products with great specs are often found to be dry and boring, this amplifier breathes new life into the music. “It follows the philosophy of PL amplifier design – still greater performance with still simpler circuitry.”
Specifications
Output power:
    2x 25 Watts Class A @ 8 ohms
    2x 50 Watts Class A @ 4 ohms
    2x 100 Watts Class A/AB @ 2 ohms
Distortion: 0.1% @ 25 Watts, 8 ohms, 1 KHz, 0.1% @ 50 Watts, 4 ohms, 1 KHz
Freq. Response: DC to 3dB @ 200 KHz
Gain: 20 dB gain
Noise: Output 100 uV unweighted 20 to 20 KHz
Damping Factor: 200
Slew: 100 V/uS
Input Impedance: 47 Kohm
Peak Current: 10 Amp output (200 Watts into 2 ohms) Independent of loudspeaker load phase.
Protection: Shutdown at 10 amps output
Idle Power draw: 200 Watts total.
Dimensions: 17” W x 17.4” D x 6” H
Weight: 46 pounds/21 kilograms
Price: $4,900 MSRP